How to Operate Plastic Granulator Correctly

 Plastic granulator machine is mainly composed of cyclone sieve, ejector, a cyclone, dust bins, induced draft fan and electrical automatic control system, users are clearly industry. As one of top brand China plastic granulator manufacturers, Aumax manufacture every plastic shredding machine in accordance with strict standards and rigorous testing.

Plastic grinder manufacturing is so strict, the operation should be also standardized, so that manufacturers and consumers can feel at ease and improve efficiency.

Loader trolley mill requires smooth and reliable. In the boot loader bridge some cases, the operation of various departments should be no abnormal sound, scraper, chains, connecting ring should be no twist scratch, twist twisting, bending deformation.

Roadway support plastic shredders need at good, solid. Its safety net and protection device to protect the deformation does not fail, as reliable as possible.

Close the handle power transmitting magnetic starter, press button two points open hand, three times, starting, idling 1 to 2 weeks, loader, a combined operation of grinder; examination was normal, the start-up signal. Immediately into use.

And the motor to run without mechanical vibration, sound and normal humidity to each of the bearing temperature does not exceed 75 ℃, motor temperature not exceeding specified by the manufacturer. Mill chain tension needs to be consistent, at full load, the amount of chain tension does not allow more than two chain link lengths, without card chain, chain jumping phenomenon. Loader swivel joint of the fusible plug or fried pieces easily damaged, can not be replaced with wood or other materials.

Plastic granulator protective network security devices should be kept intact, should always check the operation, if damaged, it should be shut down immediately. Tail protection safety devices such as the loader needs to be good, transfer loader.

Finally, it is under way to clean up plastic grinder maintenance work, which also use one of the specifications.

(1), cleaning tail, fuselage and float coal, refuse under the floating bridge;

(2), to protect the cables, water pipes, tubing, and hanging neatly;

(3) Check roadway support in ensuring the safety of the passage loader;

(4) Belt Conveyor trolley with good contact to the tail-stock, no deviation, after the transference good lap, to prevent crushing large pieces of plastic tape, to ensure the smooth flow of coal;

(5), backward loader, nose, tail to maintain a flat, linear, steady, live jack rod to be retracted.