What is the Maintenance Method of Plastic Granulator Motor?

As a Central Plastic Granulator Suppliers, share with you. During the operation of the granulator, at the same time, the granulator should be regularly maintained to make the granulator work normally, and the power system of the granulator must be regularly protected and maintained to avoid failures and ensure smooth motor operation. So how to maintain the motor of Plastic Granulator?

Plastic Granulator

1. Frequently sort out the oil and dust on the motor of the granulator. If the dust in the harsh environment is relatively large, it is recommended that we regularly arrange the motor every few days to ensure that the motor cleaning and work are smooth.

2. Check the coupling of the transmission part of the granulator to see if the coupling is hardly damaged or damaged. The damaged coupling will form many dangers. It can be replaced in time and effectively avoid many accidents.

3. Check the orientation of some fixed screws to see if they are loose. If loose, stop working, the staff should fasten it in time to avoid accidents.

4. After using the granulator bearings for a period of time, they should be promptly sorted out and replaced with lubricating grease and mechanical oil. The frequency of sorting and replacement should be determined according to the working time of the motor. The general replacement frequency is about six months for the granulator motor Lubricating grease and mechanical oil should be sorted out and replaced.

In some cases, this may be an important step before being re-used to make new plastic products. However, in most cases, the recycling of plastic waste requires more resources in sorting and separation, size reduction, washing and granulation.

In the granulator, the cutting blade is installed on an open rotor that is rotated to a high speed by a motor. The rotor is installed in a cutting room, and the national knives are installed in the cutting room. When plastic waste enters the cutting chamber, the rotating knife contacts the fixed knife to cut the plastic into small pieces. A large screen with many holes is placed at the bottom. The plastic will continue to be mixed and cut with a knife until it is small enough to fall through the screen. Therefore, by adjusting the size of the hole, the size of the cutting chips can be controlled.

When we use the granulator, we must maintain its motor. Because the motor is the driving force for the operation of the equipment, once it is damaged, it will cause the equipment to fail to operate. of.

Our company also has Heavy-Duty Plastic Granulator for sale, please contact us.